Enter a decklist or upload files to the left to get started
Pull to Refresh
Settings
Collapse All
Projects
Switch between different decks/projects. Each project has its own cards and settings.
Layout
×
Bleed
Bleed Settings
Card
Adjust position and rotation for each card back individually. Use this to fine-tune alignment for each position in the grid.
Max that fits with current layout: 4 mm
Adjust card position for perfect printer alignment. Use small values (0.1-2.0mm) for fine-tuning.
Positive = right, negative = left
Positive = down, negative = up
Use different offsets for back cards (useful for printer alignment in duplex printing). Applies to Backs-only exports and Duplex mode back pages.
Guides
Controls which side of the cut line the guides appear on. Outside places strokes in the bleed area, Inside places them within the card content, Center straddles the cut line.
Controls how far the corner guides extend along the card edge. Shorter guides are easier to hide if not cut perfectly.
Adds registration marks for Silhouette Cameo print & cut. 3-point uses marks in 3 corners, 4-point adds a mark in the bottom-right for better accuracy on distorted prints.
Darken Pixels
Apply To
Amount
Edge Width
Filter & Sort
0
1
2
3
4
5
6
7+
Export
Export an SVG cutting template based on your current layout settings. Import this into Silhouette Studio for print & cut alignment. See setup requirements in the Guides section when registration marks are enabled.
Application
Used for Scryfall lookups
Automatically fetch associated tokens after importing cards
To pick up a draggable item, press the space bar.
While dragging, use the arrow keys to move the item.
Press space again to drop the item in its new position, or press escape to cancel.